Observations always starts at Reference triplet and end at Measured triplet.Observations can be GPS baseline vectors (Dx,Dy,Dz) from RTK or post processing.LGO project stores the GPS observations.After inspection of the data processing results you may select individual or all baselines and store them in the Project database.After the GPS Processing is completed the results can be viewed using the Results View.It will intelligently select the reference and rover stations and process all possible combinations of baselines that conform to the set parameters.The baselines are processed in an order which would most likely be chosen by manual processing.Only few mouse clicks are needed to process the data.

Leica Geo Office Processing Parameters Auto Processing

A single point position computation yields absolute station coordinates in the WGS84 coordinate system.

Single point positioning uses code measurements collected at a single station during one or more occupations.

Leica Geo Office Manual Mode Single Point Positioning (SPP)

A baseline computation yields the three-dimensional coordinate differences of the roving station relative to the reference station, in the WGS84 coordinate system.

One station has to be assigned as reference site, the other as rover.

Baseline processing implies the computation of a 3-dimensional vector between two occupied sites.Baseline Processing and Single Point Positioning is possible.If the user selects the manual mode, he can configure how the data is computed.Selection of Observations (supported by the graphical Selection Mechanism) and selection of GPS processing Parameters.The GPS Processing consists of two major parts.The GPS Processing may be accessed via the GPS –proc Tab within a project.Observations collected at two stations, at the same time, and to the same satellites are combined during processing.Average (created automatically when more than 1 measuered triplet available) īaseline Vector A B Leica Geo Office What is baseline Processing?.Leica Geo Office Point Classes The following coordinate classes are available An Interval represents the occupation of a point with GPS instrument.To view the properties->right click on a point in GPS Proc tabbed view.You can re-assign an interval to a new or existing Point EID.Deleting an Interval will automatically remove the measured triplet, the observation and as well the GPS raw data from the project.When importing GPS data a point triplet Navigated or Measured is connected to each interval (depending if it is RTK or raw data).Leica Geo Office – GNSS ProcessingContents

Download leica geo office 8.4